Filter
Top Products
1. Remove the control panel from the front panel.
2. Disconnectthechassisintrusionswitchcablefromthecontrolpanel (see Figure 9).
Note the routing of the chassis intrusion cable as you remove the cable from the chassis. Chassis hooks may hold the cable in place inside
the chassis.
3. Slide the chassis intrusion switch out of its slot on the chassis and carefully remove the switch and its attached cable from the chassis.
4. Install the replacement chassis intrusion switch and cable.
5. Reset the chassis intrusion detector.
Drives
Figure 10. Drive Locations
3.5-Inch Diskette Drive
Figure 11. Diskette Drive Removal
To remove the 3.5-inch diskette drive from the drive bay, perform the following steps:
1. Disconnect the DC power and diskette interface cable from the back of the drive.
2. Press the release tab on the left side of the diskette drive, and pull the diskette drive/bracket out of the chassis.
3. Remove the drive-mountingscrewfromtheleftsideofthedrive,andremovethedrivefromthebracket(seeFigure11).
NOTE: In all of the following procedures, left and right refer to your left and right as you face the front of the computer.
1
3.5-inch diskette drive
2
5.25-inch drive slots (3)
3
3.5-inch internal bay for hard-disk drives (2)
1
Release tab