Filter
Top Products
Installing System Components 45
Figure 3-5. Removing or Installing a Diskette Drive
7
If you are permanently removing the drive, replace the 3.5-inch insert on front drive bezel. See
"Replacing an Insert on the Front Drive Bezel" on page 44.
If you are replacing the diskette drive, see "Installing a Diskette Drive" on page 45.
8
Replace the front drive bezel. See "Replacing the Front Drive Bezel" on page 43.
9
Close the system. See "Closing the System" on page 41.
10
Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
Installing a Diskette Drive
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. Before performing any procedure, see your Product Information Guide for
complete information about safety precautions, working inside the computer and protecting against electrostatic
discharge.
1
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 41.
1 arrow on the sliding plate 2 sliding plate 3 drive-stop tab
4 power cable to diskette
drive (P7)
5 data cable to diskette drive 6 data cable to system board
connector (FLOPPY)
5
6
2
3
1
4
book.book Page 45 Monday, June 5, 2006 3:20 PM