Filter
Top Products
Installing System Components 73
Bezel (Service Only Parts Procedure)
Removing the Bezel
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. Before performing any procedure, see your Product Information Guide for
complete information about safety precautions, working inside the computer and protecting against electrostatic
discharge.
1
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 41.
3
Remove the heat sink and shroud assembly. See "Removing the Processor" on page 62. Do not remove
the processor, however.
4
Remove the large processor cooling fan. See "Removing the Cooling Fans" on page 65.
5
Remove the three bezel release screws. See Figure 3-21.
6
Slide the bezel toward the top of the system, then lift it outward.
book.book Page 73 Monday, June 5, 2006 3:20 PM