Filter
Top Products
62 Installing System Components
11
Open the system. See "Opening the System" on page 41.
12
Ensure that the installed memory modules are seated properly in their connectors, and repeat step 7
through step 9.
13
When the
Memory Info
value is correct, press <Esc> to exit the System Setup program.
14
Run the system diagnostics to verify that the memory modules are operating properly. See "Running
the System Diagnostics" on page 98.
Microprocessor
You can upgrade the system processor to take advantage of future options in speed and functionality. The
processor and its associated internal cache memory are contained in a land grid array (LGA) package.
Removing the Processor
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. Before performing any procedure, see your Product Information Guide for
complete information about safety precautions, working inside the computer and protecting against electrostatic
discharge.
CAUTION: The processor and heat sink can get very hot during normal operation. Ensure that they have had
sufficient time to cool before you touch them.
1
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 41.
3
Using a #2 Phillips screwdriver, loosen the two captive screws holding the heat sink and shroud
assembly in place.
These captive screws are adjacent to the processor cooling fan housing. See Figure 3-15.
4
Tilt the heat sink and shroud assembly away from the fan housing and lift it out.
book.book Page 62 Monday, June 5, 2006 3:20 PM