Filter
Top Products
70 Installing System Components
Figure 3-19. Removing the Power Supply
Installing the Power Supply
1
Attach the cable clamp to the new power supply.
2
Align the power supply mounting holes with the mounting holes on the back panel.
3
Slide the power supply toward the back panel until it snaps into place over the power-supply release
tab.
4
Using a #2 Phillips screwdriver, install the four Phillips screws that secure the power supply to the back
panel.
5
Reattach the IDE, I/O panel, and SATA cables (if present) to the routing clamp on the side of the
power supply.
6
Depending on your system configuration, connect the following power cables:
• P1 and P2 to the system board
• P3 and P5 to the SATA or SAS drives
1 power supply release tab 2 power supply 3 screws (4)
4 cable clamp
3
1
2
4
book.book Page 70 Monday, June 5, 2006 3:20 PM