Filter
Top Products
Figure 6. Removing and Installing a Cooling Shroud
1. tabs (4) 2. cooling shroud
3. slots on the chassis (4)
Installing The Cooling Shroud
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Align the tabs on the cooling shroud with the slots on the chassis.
2. Lower the cooling shroud into the system until the tabs seat securely on the slots on the blade
chassis.
3. Close the blade.
4. Install the blade in the enclosure.
Hard Drives/SSDs
• The system supports up to four 2.5 inch SAS hard drives or two PCIe SSDs.
• All drives connect to the system board through the SSD/SAS hard-drive backplane.
• Hard drives/PCIe SSDs are supplied in special hot-swappable drive carriers that fit in the drive slots.
• All empty drive slots must have hard-drive blanks installed.
The following table lists the supported hard drive/SSD configurations.
30