Filter
Top Products
Figure 16. Removing and Installing a Processor/DIMM Blank
1. processor socket 2. processor/DIMM blank
3. tabs (4) 4. heat sink retention screws (4)
Installing A Processor/DIMM Blank
1. Remove the blade from the enclosure.
2. Open the blade.
3. If installed, remove the processor and heat sink.
4. Position the processor/DIMM blank on the system board with the holes on the tabs of the processor/
DIMM blank secured to the heat sink retention screws on the system board.
5. Install the cooling shroud.
6. Close the blade.
7. Install the blade in the enclosure.
44