Filter
Top Products
8. If applicable, install the following:
a. system board
b. mezzanine card(s)
c. SSD/hard-drive backplane(s)
9. If applicable, close the latch on the mezzanine card support bracket.
10. Install the cooling shroud.
11. Close the blade.
12. Install the blade in the enclosure.
Figure 22. Installing and Removing a Memory Module or Memory Module Blank
1. memory module or memory blank 2. edge connector
3. ejectors (2) 4. socket
5. alignment key
Installing Memory Modules
WARNING: The memory modules are hot to the touch for some time after the system has been
powered down. Allow time for the memory modules to cool before handling them. Handle the
memory modules by the card edges and avoid touching the components or metallic contacts on
the memory module.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To ensure proper system cooling, memory-module blanks must be installed in any
memory socket that is not occupied. Remove memory-module blanks only if you intend to install
memory modules in those sockets.
CAUTION: If you are permanently removing a processor, you must install a socket protective cap
and a processor/DIMM blank in the vacant socket to ensure proper system cooling. The
processor/DIMM blank covers the vacant sockets for the DIMMs and the processor.
1. Remove the blade from the enclosure.
2. Open the blade.
62