Filter
Top Products
212 Management: Installing Array Components
Figure 16-3. Removing and Installing a 2.5-Inch Hard-Drive Blank
Installing a Drive Blank
1
If installed, remove the front bezel
. See
"Removing the Front Bezel" on
page 210.
2
Insert the drive blank into the drive bay until the blank is fully seated.
3
Close the handle to lock the blank in place.
4
If applicable, replace the front bezel. See "Installing the Front Bezel" on
page 210.
Removing a Hard Drive
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1
If installed, remove the front bezel
. See
"Removing the Front Bezel" on
page 210.
1 drive blank 2 release tab
1 2
book.book Page 212 Thursday, December 9, 2010 3:20 PM