Filter
Top Products
Configuration: About Your Storage Array 77
Configuring Alert Notifications
MDSM can send an alert for any condition on the storage array that requires
your attention. Alerts can be sent as e-mail messages or as Simple Network
Management Protocol (SNMP) trap messages.
You can configure alert notifications either for all the storage arrays or a single
storage array.
To configure alert notifications for all storage arrays:
1
In the EMW, select the
Setup
tab.
2
Select
Configure Alerts
.
The
Configure Alerts
dialog appears.
3
Select
All storage arrays
.
4
Click
OK
.
The
Configure Alerts
dialog appears. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 77. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 80.
To configure alert notifications for a single storage array:
1
In the EMW, select the
Devices
tab.
2
Select the relevant storage array, then select
Edit
Configure Alerts
.
The
Configure Alerts
dialog appears. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 77. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 80.
Configuring E-mail Alerts
For more information on configuring alert notifications, see "Configuring
Alert Notifications" on page 77.
To configure e-mail alerts:
1
Open the
Configure Alerts
dialog by performing one of these actions:
• In the tree view or the table view on the
Devices
tab in the EMW,
select a node, and then select
Edit
Configure Alerts
. Go to step 3.
•In the
Setup
tab in the EMW, select
Configure Alerts
. Go to step 2.
2
Select one of the following radio buttons to specify an alert level:
book.book Page 77 Thursday, December 9, 2010 3:20 PM