Filter
Top Products
Adding and Replacing Parts 179
11
Replace the computer cover (see "Replacing the Computer Cover" on
page 161).
NOTICE: To connect a network cable, first plug the cable into the network device
and then plug it into the computer.
12
Connect your computer and devices to electrical outlets, and turn them
on.
13
Enter the system setup program (see
"System Setup
" on page 89) and
restore the settings that you recorded in step 1.
14
Properly dispose of the old battery. For more information, see your
Product
Information Guide
.
Processor
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the
Product Information Guide
.
CAUTION: To guard against electrical shock, always unplug your computer from
the electrical outlet before opening the cover.
NOTICE: To prevent static damage to components inside your computer, discharge
static electricity from your body before you touch any of your computer’s electronic
components. You can do so by touching an unpainted metal surface on the
computer.
Removing the Processor
1
Follow the procedures in "Before You Begin" on page 151.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 153).
3
Rotate the hard-drive carrier out of the computer (see "Rotating the Hard
Drive Carrier Out of the Computer" on page 156).
4
Rotate the processor access door to its open position.