Filter
Top Products
196 Adding and Replacing Parts
To install a SAS hard drive:
a
Connect the power cable to the SAS connector.
b
Connect the SAS connector to the hard drive.
c
Connect the other end of the SAS cable to the SAS controller card.
9
Ensure that all connectors are properly cabled and firmly seated.
10
Replace the computer cover (see "Replacing the Computer Cover" on
page 262).
NOTICE: To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
1 serial ATA cable 2 SATA0 connector
3 SATA1 connector 4 power cable
5 secondary hard drive bay 6 hard drive in primary hard drive
bay
6
4
1
2
5
3