Filter
Top Products
198 Adding and Replacing Parts
7
If you are removing a SAS drive:
a
Disconnect the power cable form the SAS connector.
b
Disconnect the SAS connector from the hard drive.
c
Disconnect the SAS connector from the SAS controller card.
8
Slide the sliding-plate lever to the right to release the shoulder screw and
slide the drive out of the lower 3.5-inch drive bay.
9
Set the drive aside in a secure location.
1 power cable 2 serial ATA cable
3 SATA connector 4 optional third serial ATA/SAS
hard drive
1
2
3
4