Filter
Top Products
222 Adding and Replacing Parts
7
Slide the sliding-plate lever to the right to release the shoulder screw and
slide the drive or Media Card Reader out of the 3.5-inch drive bay.
Installing a Floppy Drive or Media Card Reader (Tower Computer)
NOTICE: In a tower configuration with 4 hard drives, there can only be one floppy
drive or Media Card Reader which must be installed in the lower 3.5-inch drive bay.
In this case, the 4th hard drive (which must be a SATA drive) will occupy the upper
3.5-inch drive bay.
1
Follow the procedures in "Before You Begin" on page 143.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 145).
3
Remove the front panel (see "Removing the Front Panel" on page 154).
4
If you are installing a new floppy drive or Media Card Reader, remove the
drive-panel insert (see "Removing a Drive-Panel Insert" on page 218) and
remove the shoulder screws from the inside of the drive-panel insert.
Attach the screws to the new drive.