Filter
Top Products
204 Adding and Replacing Parts
6
If you are removing a SATA drive,
disconnect the serial ATA cable from the
back of the hard drive and from the SATA connector on the system board.
7
If you are removing a SAS drive:
a
Disconnect the power cable form the SAS connector.
b
Disconnect the SAS connector from the hard drive.
c
Disconnect the SAS connector from the SAS controller card.
8
Slide the sliding-plate lever to the right to release the shoulder screw and
slide the drive out of the lower 5.25-inch drive bay.
1 power cable 2 power supply
3 serial ATA cable 4 SATA connector
5 optional serial ATA hard drive in
lower 5.25-inch drive bay
1
2
3
4
5