Filter
Top Products
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
148
Switch will send a trap message to the SNMP agent and the Switch log when an ARP packet is received that doesn’t
match the IP-MAC binding configuration set on the Switch.
To view this window click, Security > IP-MAC-Port Binding > IMP Binding Global Settings
Figure 5 - 4 IMP Binding Global Settings window
The following parameters can be set:
Parameter Description
ACL Mode
This field will enable and disable the ACL mode for IP-MAC binding on the Switch, without
altering previously set configurations. When enabled, the Switch will automatically create two
ACL packet content mask entries which will aid the user in processing certain IP-MAC binding
entries created. The ACL entries created when this command is Enabled can only be
automatically installed if the Access Profile table has two entries available of the possible six
entries allowed.
Trap / Log
This field will enable and disable the sending of trap log messages for IP-MAC binding. When
enabled, the Switch will send a trap log message to the SNMP agent and the Switch log
when an ARP packet is received that doesn’t match the IP-MAC binding configuration set on
the Switch.
DHCP Snoop State
Use the pull-down menu to enable or disable the DHCP Snoop State for IP-MAC Binding.
Click Apply to implement the settings made.
IMP Binding Port Settings
Select a port or a range of ports with the From Port and To Port fields. Enable or disable the port with the State, Allow
Zero IP and Forward DHCP packet field, and configure the port’s Max entry.
To view this window, click Security > IP-MAC-Port Binding > IMP Binding Port Settings as shown below:
Figure 5 - 5 IMP Binding Port Settings window
The following fields can be set or modified:
Parameter Description