Filter
Top Products
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
29
Parameter Description
IP Address
Enter the IP address of the interface.
Subnet Mask
Enter the Subnet mask of the interface.
Gateway
Enter the default gateway of the out of band management networks.
Status Allows the user to Enable or Disable the IP interface.
Link Status
Displays the current configurations of the out of band management interface.
Click Apply to implement changes.
External Alarm Settings
This window is used to display and configure the messages receiving from the RJ-45 alarm port when external alarm
occurs. The alarm port is designed to collect the alarm message generated by the 3-party alarm generator. While
receiving the alarm messages, the Switch will send out alarm traps to the NMS according to the message you
configured.
To view this window, click Configuration > External Alarm Settings as shown below:
Figure 2 - 28 External Alarm Settings window
To modify an existing message click the corresponding Edit button and retype the new Alarm Message as shown
below.
Figure 2 - 29 External Alarm Settings window – Edit
Enter the new information and click Apply to implement changes made.
DHCP Auto Configuration Settings
The DHCP auto configuration function on the Switch will load a previously saved configuration file for current use.
When DHCP auto configuration is Enabled on the Switch, the DHCP reply will contain a configuration file and path
name. It will then request the file from the TFTP server specified in the reply.
To view this window, click Configuration > DHCP Auto Configuration Settings as shown below:
Figure 2 - 30 DHCP Auto Configuration Settings window