Filter
Top Products
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
31
Password Encryption
Password Encryption Status can be Enabled or Disabled in this window, it is Disabled by default. Password encryption
allows the user to encrypt a password in the configuration file for additional security. Select Enabled to change the
password into encrypted form. When password encryption is disabled, the password will be in plain text form. However,
if the user specifies the password in encrypted form, or if the password has been converted to encrypted form by the
last Enable password encryption command, the password will still be in encrypted form and cannot be reverted back
to plaintext form.
To view this window, click Configuration > Password Encryption as shown below:
Figure 2 - 34 Password Encryption window
Clipaging Settings
Clipaging Status can be Enabled or Disabled in this window, it is Enabled by default. Clipaging settings are used when
issuing a command which causes the console screen to rapidly scroll through several pages. This command will cause
the console to pause at the end of each page.
To view this window, click Configuration > Clipaging Settings as shown below:
Figure 2 - 35 Clipaging Settings window
Firmware Information
The following screen allows the user to view information about current firmware images stored on the Switch.
To view this window, click Configuration > Firmware Information as shown below:
Figure 2 - 36 Firmware Information window
This window holds the following information:
Parameter Description
ID
States the image ID number of the firmware in the Switch’s memory. The Switch can store two
firmware images for use. Image ID 1 will be the default boot up firmware for the Switch unless