Filter
Top Products
DGS-3700-12/DGS-3700-12G Series Layer 2 Gigabit Ethernet Switch User Manual
12
Enter the new VLAN Name and Admin. State and click Apply. To edit an entry for IPv4 features click the
corresponding IPv4 Edit button.
Figure 2 - 7 IPv4 Interface Settings Edit window
The following parameters can be configured:
Parameter Description
Interface Name
Displays the interface being edited.
VLAN Name
Enter the name of the VLAN corresponding to the interface.
IPv4 Address
Enter an alternative IPv4 address. Currently an interface can only have one IPv4 address defined.
Therefore multinetting configuration of IPv4 must be done through creation of a secondary
interface on the same VLAN, instead of directly configuring multiple IPv4 addresses on the same
interface.
Subnet Mask
Enter the corresponding subnet mask.
IPv4 State
This function allows user to enable the IPv4 address on the IP interface.
Click Apply to implement changes made.
To edit an entry for IPv6 features click the corresponding IPv6 Edit button.
Figure 2 - 8 IPv6 Interface Settings Edit window
The following parameters can be configured:
Parameter Description
Interface Name
Displays the interface being edited.
VLAN Name
Enter the name of the VLAN corresponding to the interface.
IPv6 Network
Address
Enter the IPv6 Network Address to be configured. The interface can have multiple IPv6 addresses
defined. Configuration of IPv6 addresses must be done through the command config ipif.
IPv6 State
Allows the user to enable or disable the IPv6 state on the interface.
NS Retransmit
time (0-
4294967295)
This field is used to set the interval, in milliseconds that the Switch will produce neighbor
solicitation packets to be sent out over the local network. This is used to discover IPv6 neighbors
on the local network. The user may select a time between 0 and 4294967295 milliseconds. The
default is 0.