Filter
Top Products
2-58 INSTALLATION AND SETUP
MON2000
2350A Ethernet Installation JULY 2010
2.15.3 2350A Ethernet Installation
To add an ethernet assembly:
1. To add an ethernet card at the GC
Controller site, remove the Controller
enclosure's front panel.
(a) For the explosion-proof Controller, the
front panel is secured by 16 screws.
Remove those screws first.
(b) Then carefully lower the front panel on
its bottom hinges. The front panel is
heavy, so make sure it does not drop and
cause damage.
(c) For the rack mount Controller, the rear
of the enclosure is open; it allows access
for most field wiring procedures without
removing the enclosure.
(d) Locate the GC Controller's Terminal
Board for Field Wiring (TB). The TB is
attached to the GC Controller's Card
Cage Assembly, facing the enclosure's
front panel. (In the rack mount
Controller, the TB faces outward toward
the rear of the enclosure.)
2. Loosen the six screws that secure the TB.
Then unplug the TB from its connections at
the back, top of the board.
3. Lower the TB down and out of the way, held
in place by its ground straps at the bottom
of the board. This exposes the Card Cage
Assembly.
4. Loosen the four screws that secure the Card
Cage Assembly to the chassis. Then remove
the Card Cage Assembly away from its
chassis mount so that it is easy to work on.