Filter
Top Products
2-62 INSTALLATION AND SETUP
MON2000
Ethernet TCP/IP Settings JULY 2010
2.15.4 Ethernet TCP/IP Settings
If you plan to connect via an Ethernet
connection, use the following instructions.
To configure the Ethernet TCP/IP settings for
the 2350A GC Controller:
1. Obtain the IP Address, Subnet Mask, and
Gateway addresses (numbers) for the
Target 2350A GC Controller from your
supervisor or Information Technology
Department.
2. Use the Application > TCP/IP menu to
access this function.
3. The TCP/IP dialog appears.
4. Go to the Use DHCP/Specify an IP Address
field and select Specify an IP Address.
5. In the IP Address field, enter the IP Address
(number) obtained from your Supervisor or
the Information Technology Department.
If the controller has never been configured for Ethernet
communications, logon to the Model 500 GC using either the
Direct Connect option, or connect remotely via a Modem.