2-60 INSTALLATION AND SETUP
MON2000
2350A Ethernet Installation JULY 2010
No software setup is required for this board.
(a) If the 2350A BOS version is v1.84 or
later, ensure that J6 Jumper on pins 13-
14 of J1 has been removed.
(see Figure 2-9 and Figure 2-10).
7. If a modem is installed, remove the phone
cord.
8. Install the Ethernet card and set the
jumpers as shown below.
Table 2-7 System Interface Board Cable Connections
Connection Ribbon Cable
J5 and J6 Analog I/O
J8 Com3
J10 Com4
J4 Printer
J11 Com2
J2 and J3 Digital I/O
J12 Front Panel and Keyboard
(if installed)
Table 2-8 CPU Board Cable Connections
Connection Ribbon Cable
J1 Com1, Com2, and Printer
J4 and J7 Digital I/O
J6 Com3 and Com4