Filter
Top Products
A-8 Appendix A
• options.386
• dmadcp.asm
• dmapc.asm
• dma.equ
• dcp286d.equ
• mac.equ
• scc.equ
• assem.bat
• build.bat
• dmatest.bat
• dmatest.doc
Check the diskette to make sure all these files are present. After you have
done this, make a backup copy of the diagnostic diskette for regular use. If
running the diagnostics from a hard drive, create a subdirectory in your hard
disk, then copy the diagnostics to that subdirectory. In both cases, place the
original Emulex diskette in a safe place.
Running the Diagnostic
The Diagnostic Platform can be used to configure and run diagnostics on
several adapters at the same time. The adapter may be all the same type or
any combination of supported models. The list of tests and their order of
performance are individually configurable for each adapters. To run the
diagnostic program, perform these steps:
1) Boot the system under DOS and insert the Emulex diagnostic diskette in
drive A:
2) Set the default drive path to: A:
3) At the DOS prompt, type:
>
A:dcpdiag3
The Diagnostic Main Menu appears. You are now ready to run the
desired diagnostics.