Filter
Top Products
2-2 Chapter 2
DCP_link features an 80x86 microprocessor based “intelligent” WAN
adapter to provide powerful co-processing capabilities. The adapter utilizes
1Mb of on-board shared memory to transfer commands and data to the
NetWare server. DMA channels are included to support full-duplex
operation.
This chapter describes the factory default configuration of the
DCP286
i/386i/486e and tells how to configure the board for WAN
applications.
Factory Default Settings
This factory default configuration is correct for all WAN applications:
• DCP286i, DCP386i and DCP486e compatibility level
• 1 Megabyte memory size
• Window Group Select 16K, 32K, 64K, 1MB
• Control Register 4 Read option enabled
IMPORTANT: The base I/O address and the IRQ level
must not be in conflict with any other adapter on
the server. Verify that both the base I/O address
and the interrupt level (IRQ setting) configured on
the adapter match the software configuration. For
more information, refer to
Chapter 6.
Verify that the following factory default parameters are appropriate for your
server environment. If you can use the factory default configuration, refer to
the DCP_link Quick Start User’s Guide.
Base I/O address 33C hex
Interrupt Level (IRQ) 3
Data clock direction DTE