Filter
Top Products
Software Configuration 5-5
Configuring with INETCFG
Important: You must use INETCFG to configure the
Emulex software and hardware you have
installed in your server/router.
If INETCFG is not running, complete the following steps to load it:
1) At the server prompt, type
>
LOAD INETCFG <Enter>
The Internetworking Configuration main menu is displayed.
Figure 5-1
Note: The first time you run INETCFG, you will be
prompted to move all commands from
Autoexec.ncf to other files that INETCFG
uses. Answer Yes to this prompt.
2) If the Internetworking Configuration main menu is not
displayed, please refer to the Emulex DCP_link Advanced
Configuration Manual for instructions on transferring LAN
driver, protocol, and remote access commands.
3) Select
Boards, then press <Enter>.
The Configured Boards window is displayed.