Filter
Top Products
Hardware Installation 3-3
This section describes the procedure for installing the DCP286i-SBC, the
DCP386
i, and the DCP486e WAN adapter in your server/router. Brief
troubleshooting procedures are also provided.
Installing the Emulex Adapter
To install the adapter perform these steps:
1) Turn off power to the system unit. Remove the power cord from the unit
and the AC outlet.
2) Loosen attaching screw and remove the top cover of the system unit.
3) Remove the cover from an empty slot. The DCP286
i-SBC and DCP386i
may be installed in a 16-bit ISA and EISA slot. However, the DCP486
e
must be installed in an EISA slot.
4) Slide the board into the empty slot. Press firmly to seat the board.
5) Secure the board with the screw removed in step 3.
6) Replace the system unit cover and reconnect the power cord.
7) Connect cable.
Before connecting the external device, you may want to perform a complete
functional test of the unit. Refer to Section 4 for instructions on running the
diagnostics.