Filter
Top Products
The Cut Sheet Feeder
Testing the Printer in the Cut Sheet Feeder Mode
When you perform the cut sheet feeder self test, the printer counts
the number of lines on the page. As shown on the following page,
the number of lines counted is printed out at the bottom of the first
test page. This number is the default page-length setting. This
setting, however, can be overridden by software commands.
Running the self test is the same as when the cut sheet feeder mode
is off. The steps below are for a self test in draft mode.
Note: Run the self test using paper that is 8¼ inches (210 mm)
wide on the standard width printer and 14 inches (360 mm) wide
on the wide carriage printer.
Using the Printer Options
5-9