Filter
Top Products
Using the control panel
To operate the cut sheet feeder manually from the control panel
when the printer is in the cut sheet feeder mode, first make sure that
the printer is off line.
LINE FEED
FORM FEED
LOAD/EJECT
When there is paper in the printer, press this
button to feed the paper one line or hold it down
to feed the paper continuously.
When there is no paper in the printer, press this
button to load paper from the cut sheet feeder.
When there is paper in the printer, press this
button to eject the sheet.
When there is no paper in the printer, press this
button to load the paper from the cut sheet
feeder. When there is paper in the printer, press
this button to eject the sheet.
Using software
The following commands cause the printer to eject the sheet in the
printer without loading the next sheet.
FF:
Form feed
ESC EM R:
Ejects a sheet in the cut sheet feeder mode
Note: The ESC EM command is a software command used to
control the operation of the cut sheet feeder. For more information
about this command, see the Command Summary in Chapter 9.
5-14
Using the Printer Options