Filter
Top Products
Maintaining the Projector 103
Replacing the Lamp
The projection lamp lasts up to 7000 hours. (Lamp life results will
vary depending upon environmental conditions and usage.) Turn the
projector off when not in use. Continuous 24-hour-a-day use may
reduce the overall life of this product.
When the lamp nears the end of its life (as determined from projector
usage), the message
LAMP REPLACE appears on the screen and the
lamp warning light flashes orange. To maintain projector
brightness and image quality, replace the lamp as soon as possible.
It is also time to replace the lamp when:
■ The projected image gets darker or starts to deteriorate.
■ The lamp warning light flashes red (the lamp is burnt out).
Contact your dealer or call EPSON at (800) 873-7766 in the United
States for a replacement lamp. Request part number
V13H010L26.
In Canada, please call (800) 463-7766 for dealer referral.
Follow these steps to replace the lamp:
1. Turn off the projector.
2. When the power light stops flashing, unplug the power cord.
3. Let the projector cool for at least half an hour (if it has been on).
The lamp is extremely hot immediately after use.
4. If the projector is mounted on the ceiling, remove the rear cover.
note
You can check how long
the lamp has been in use
(see page 105).
warning
Let the lamp cool fully
before replacing it.
In the unlikely event that
the lamp has broken, small
glass fragments may be
present and should be
removed carefully to avoid
injury.
Release tab to
remove rear cover