Filter
Top Products
Giving Your Presentation 53
Setting the Remote Control ID
The remote control’s default ID is zero. If you need to change it,
follow these steps:
1. Press the ID button on the remote control. You see it light up.
2. Press one of the numbered buttons on the remote control to select
the desired ID (0 through 9). Select zero to control all projectors,
or select a number to match the ID of the projector(s) you want to
operate.
The
ID button’s light shuts off and the new ID is registered.
If you would like to check the remote control’s current ID, do the
following:
1. Press the
ID button twice in succession. After a moment, the
button flashes.
2. Count the number of flashes; this number corresponds to the
remote control’s ID. (If it doesn’t flash, it is set to zero.)
0
Zero
Nine