Filter
Top Products
Displaying and Adjusting the Image 47
Shutting Down the Projector
When you’ve finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. If you’ve connected a computer or notebook, shut it down first;
otherwise you may not be able to see your computer’s display to
shut it down properly.
2. To turn off the projector, press the red
Power button on the
projector or remote control.
You see a confirmation message. (If you don’t want to turn it off,
press any other button.)
3. Press the
Power button again. The power light flashes orange for
about a minute as the projector cools down. After the projector
has cooled, the orange light stays on and the exhaust fan shuts off.
If you want to turn the projector on again, wait until the orange
light stops flashing. Then press the
Power button.
4. Turn off and disconnect any equipment plugged into the
projector.
5. If you extended the feet, press the side buttons to retract them.
6. Replace the lens cap and unplug the power cord.
note
When the projector has not
received any input signals
f
or 30 minutes, it
automatically turns off the
p
rojector lamp and enters
“sleep mode.” This conserves
electricity, cools the
p
rojector, and extends the
life of the lamp. If you want
to start projecting again,
p
ress the Power button. If
y
ou are done using the
p
rojector, unplug the power
cord. To turn off sleep mode,
see page 77. If
Standby
Mode
has been set to
Network ON (see page 76),
the lamp will turn off but
the projector will not go into
f
ull sleep mode.
Power button
Power OFF?
Power OFF?
Yes
es
:Press button
Press button
No
No
:Press any other button
Press any other button
caution
To avoid damaging the
projector or lamp, never
unplug the power cord when
the power light is green or
flashing orange.