Filter
Top Products
Giving Your Presentation 55
Controlling the Picture and Sound
You can preview and select your picture sources, temporarily turn off
the picture and sound, freeze the action, zoom in on the picture,
display a picture-in-picture image, and adjust the brightness and
volume.
Switching Between Picture Sources
If your projector is connected to more than one computer and/or
video source, you can switch between the different sources:
■ On the projector’s control panel, there are two Source buttons:
Press the
Computer/DVI button to switch between equipment
connected to the Computer 1, Computer 2, and DVI ports. Or
press the
Video/BNC button to switch between equipment
connected to the Video, S-Video, and BNC ports.
■ On the remote control, there are seven Source buttons. Use them
to switch between equipment connected to the port identified on
each button.
Note that the Computer 1, Computer 2, and BNC ports can be set up
to use different input signals (for example, Analog RGB or RGB
Video)—so if you have equipment connected to one of these ports, it’s
important to make sure the correct signal is selected to match the
equipment you’re using. You can change the input signal settings
using the projector’s menu system; see page 75.
After you select a source, the screen goes dark for a moment before the
image appears.
note
You can fine-tune the
picture and sound quality as
described in Chapter 4.
Source buttons
note
The EasyMP
™
source
option is not supported for
this projector.