2-8 Setup Rev. B
5. Close the peeler holder.
Note:
Removing the issued label enables the label peeler detector to detect a PAPER END and the printer to issue
the next label. If the first label is not removed when using the label peeler issuing mode, the thickness of the
label and the backing paper overloads the peeler holder, possibly stopping the paper feed motor.
When the label is completely fed to the peeling position, the printer goes in the label removal waiting state.
The user is required to remove the label by him/herself.
When the label peeler detector detects the paper at the power on, the printer goes in the label removal
waiting state. In this case, the ERROR LED is turned on. The user is required to remove the label by him/
herself.
If the printer’s power is turned off while the label peeler detector detects the paper presence, the printer
goes into the label removal waiting state when the power is turned on. Therefore, make sure to remove the
label when the power is turned off.