Filter
Top Products
2-10 Setup Rev. B
Adjusting Various Settings
This printer is able to be adjusted for the items below:
❏ DIP switch (handshake of serial communication conditions)
❏ Memory switch (status notice transmission and buzzer conditions)
❏ Roll paper width
Note:
When you adjust these items, we recommend you to confirm the new setting. You can confirm the settings
by running a self-test. See “To Confirm the Current Setting of the Printer” on page 2- 3
DIP switches
This printer has DIP switches 1-2, 1-3, and 1-4. These are located as shown in the figure below.
The combination of DSW1-2, DSW1-3, and DSW1-4 switches the RS-232 serial interface signal
line data.
Note:
Make sure the printer is turned off.
DSW 1 is fixed to OFF.
Any combinations other than above must not be used.
DTR/DSR control is selected as the default.
DIP switch
Handshake DSW1-2 DSW1-3 DSW1-4
DTR/DSR ON OFF ON
RTS/CTS OFF ON OFF
DIP switches