Filter
Top Products
Rev. B 2-15 Setup
TM-P60 with Peeler Technical Reference Guide
Preparing a host PC for setting up a printer
At first, prepare a PC (trial host PC) to set up a printer. The requirements for the trial host PC are
the following:
❏ OS: Windows 2000 professional, Windows XP professional
❏ Communication port: 802.11b or serial port equipped
When you use the utility (TM Net Win Config Ver. 2.00 or later), you should install it in the host
PC before setting up the TM-P60 with Peeler. See “Install” in Appendix A for the installation
procedure.
Note:
When you set up the printer by using wireless LAN, the LAN setting of host PC is changed to correspond
to the LAN setting of TM-P60 with Peeler temporarily.
There are three way for installing TM-P60 with Peeler to wireless LAN. The following table lists required
setting item for trial host PC.
Confirming the current LAN setting of the printer
Confirm the current LAN setting of the printer according following procedure.
1. Turn on the printer’ s power.
2. Open the peeler cover by using the roll paper cover open button.
3. Press the FEED button until the printer beeps (about 2 seconds).
4. Close the peeler cover.
5. The printer prints the current LAN setting (Status sheet).
Note:
The printed result (Status sheet) is necessary at the next step.
The printer may beep when turned on. It is caused by the host PC’s LAN setting not corresponding to the
printer’s setting. Ignore the beeping.
When you connect serial cable (RS-232C) at turning on printer, this mode is disable.
Using Browser
Using TM Net Win Config
(in wireless LAN)
Using TM Net Win Config
(with serial interface (RS-232C))
Required items
(wireless LAN items)
Networkmode
(communication mode)
Networkmode
(communication mode)
“not required to change any
network items ”
SSID SSID
WEP key WEP key
IP address IP address (On the utility, you have to
select serial I/F communication
condition)
Subnet mask Subnet mask