Filter
Top Products
Rev. B 2-17 Setup
TM-P60 with Peeler Technical Reference Guide
3. Connect the serial interface cable (option) to the printer and the serial port of the host PC.
4. Turn on the printer while pressing the FEED button.
5. The printer prints the self test result, which is necessary for the next step.
Note:
If you connect the serial cable to the printer while turning it on, the printer doesn’t support serial
communication. Turn off the printer before connecting the cable.
Confirming the connection between the host PC and printer
You can select from these two methods to confirm:
• Using Utility (TMNetWinConfig)
• Using Web browser
The following sections describe each method.
Note:
Before you using Utility (TMNetWinConfig), you have to install it into your host PC. About install it,
“Install” on page A- 4
When you connect TM-P60 with Peeler to host PC with serial cable, you have to use the utility to confirm
the connection. See “When you use the Utility (TMNetWinConfig) to set up the connection” on page 2-
17.
When you use the Utility (TMNetWinConfig) to set up the connection
You can confirm the connection this way when you select either connection (wireless LAN, or
RS-232C)
1. Run “TMNetWinConfig“ on the host PC.
Note:
If the utility hasn’t been installed on the host PC, install now.
2. Turn on your printer.