Filter
Top Products
2-12 Setup Rev. B
* “Time for auto power off”: When a printer isn’t received any data from host PC, and isn’t operated anything (ex.
opening the roll paper cover, pressing the FEED button) during the specified time, the printer turns off itself
automatically.
Note:
When this printer connected with serial interface, the data length is always “8 bit.“ The handshake is
changed by a DIP switch; see “DIP switches” on page 2- 10 for details.
Adjusting Roll paper width
6 paper widths from 29.5 mm to 57.5 mm are available by using the roll paper guide. If you
remove the roll paper guide, you can also select 59.5 mm.
1. Press the button and open the peeler holder and the roll paper cover.
2. Remove the roll paper if there is one.
3. Insert your finger into the hole of the roll paper guide and lift it upward. Undo the top part
that is fixed in one of the slots.
4. Move the roll paper guide to the position matching the width of the paper you are using.
5. Insert the top of the roll paper guide and press it down until it clicks.
6. Insert the roll paper.
Note:
Do not increase the paper width after you have used a narrower width because if the printer has ever been
used with narrow paper, part of the head contacts the platen. Therefore, when a wider setting is used, part
of the head or the cutter blade may be worn out, which can cause poor printing and a blunt cutter blade.
Customize values
Function Selectable value
Time for auto power off Disable, or 1 ~ 60 minutes (Default: 20 minutes)
Print density 70%, 75%, 80%, 85%, 90%, 95%, 100%, 105%, 110%, 115%, 120%,
125%, 130%, (Default: 100%)
Serial communication
Function Selectable value
Baud rate 9600 bps
19200 bps (default)
384000 bps
Parity None (default)
Odd
Even