Epson TM-P60 Label Maker User Manual


 
Rev. B 2-27 Setup
TM-P60 with Peeler Technical Reference Guide
1. Installation.
Execute the Setup.exe in DISK. and continue to install by following the wizard instructions.
2. Set up the device and environment.
1. Set the device setting by using SetupPOS utility.
Select the device and I/F setting.
Device specified setting. (set the specified setting of the device)
2. Execute the CheckHealth
Device communication test.
If you get "SUCCESS", the setting of the device is right.
If you get ResultCode (error), re-check the device connection setting by following the
User's Manual.
After performing the above procedure, use an OPOS compliant program in your system.
Note:
Please refer to the sample program when you make a program.
The OPOS ADK provides a sample program for each device class. The sample programs are intended
as programs to serve as references for application developers. The ways to use the principal methods
and properties for each device are introduced in the form of Visual Basic and Visual C++ programs. In
this manual, it is introduced in the form of Visual Basic.
Package contents of EPSON OPOS ADK
Package contents of EPSON OPOS ADK are same as that of the previous one.
Installer
SetupPOS Utility
OPOS Controls
Manual
User’s Manual: Installation of the EPSON OPOS ADK, Configurations, and explanations
of the attached tools.
ADG: Detailed information on the each device to support the development.
Sample Program
Sample program for VB and VC (for each device class)
ADG for General: General information on the development.
ADG for Common Information: Common information to all the devices.
ADG for device class: General information on the device class.
ADG for model: Specific explanation on the device.
Sample program: Information on the Sample Programs.