Filter
Top Products
Rev. B Troubleshooting 3-1
TM-P60 with Peeler Technical Reference Guide
Chapter 3
Troubleshooting
This section describes general troubleshooting.
3.1 LED Blinking Pattern
3.1.1 Error Types
The printer stops all printer operations, goes offline, and the ERROR LED blinks when an error
is detected.
ERROR Description
ERROR LED Blinking Pattern
Recovery
Printer temperature
error (*1)
The internal temperature
of the printer is extremely
high
Recovers automatically
when the printer cools
Paper error
(Sa=0)
The basic position on the
label cannot be detected
Recovers automatically
when the cover is
opened
Layout error Paper layout differs from
the actual paper
Paper jam occurs
Recovers by error
recovery command
Circuit error The circuit board doesn’t
work
Impossible to recover
Memory error The printer does not work
correctly in R/W checking.
Impossible to recover
Voltage error The power supply voltage
is extremely high or low
Impossible to recover
Software error The firmware does not
work correctly.
Impossible to recover.
The radio unit error The IEEE802.11b radio
interface unit doesn’t
work.
Impossible to recover
Overload error Temperature of thermal
head is abnormally high.
Temperature of
IEEE802.11b wireless
interface communication
unit is abnormally high.
Impossible to recover
Battery charging error Battery voltage does not
reach the prescribed
voltage.
Battery charging is not
performed.
Replace the battery
320 ms