Filter
Top Products
Rev. B Troubleshooting 3-3
TM-P60 with Peeler Technical Reference Guide
3.3 Printer Beeps When the Power is Turned on
When printer can’t find any access points with the current wireless LAN setting, the printer
beeps to warn you. [See “Printer Beeps” (page 3-2) for the beeping pattern.] In this case, you
should change the LAN setting of this printer or your access point. For details, see “Installing
your wireless LAN” (page 2-14).
3.4 Paper Jam
When there is a paper jam, follow the procedure below.
1. Open the roll paper cover and the peeler cover.
2. Remove the jammed paper.
3. Close the covers
4. Transmit the error recovery command.
Note:
For error recovery command information, see the manual for each control method (OPOS, Advanced
Printer Driver, ESC/POS commmand).
3.5 To Confirm the Current Setting of the Printer
This printer has two functions to confirm the current setting of the printer.
❏ Self test mode
This mode prints all settings of the printer and a character printing test on roll paper.
(Ex: serial communication condition, wireless LAN setting, memory switch setting, etc...)
❏ Status sheet printing
This prints wireless LAN settings on roll paper.
3.5.1 Self test mode
The self test lets you know if your printer is operating properly. It checks the control circuits,
printer mechanisms, print quality, control software version, and DIP switch settings.
This test is independent of any other equipment or software, so it is a good idea that run it when
you first set up the printer and if you have any trouble. If the self test works correctly, the
problem is in the other equipment or the software, not the printer.
1. Make sure the printer is turned off and the peeler cover is closed properly.