Filter
Top Products
Matrix 12800 Operation, cont’d
FPC 5000 Front Panel Controller • Matrix 12800 Operation3-24
TCP/IP screen
The TCP/IP screen (figure 3-15) consists of fields from which administrators can
observe and edit IP administration and system settings.
Figure 3-15 — TCP/IP screen
There are two levels of FPC 5000 password protection: administrator and user.
Administrators have full access to all Matrix 12800 editing functions. Users cannot
change any settings on the TCP/IP screen.
Editing many of the TCP/IP settings while connected via the FPC 5000 can
immediately disconnect the user from the Matrix 12800. Extron recommends
editing these fields using the switcher’s RS-232/422 link (refer to the Matrix
12800 Wideband, Sync, or Audio Switchers User’s Manual, part
#68-556-01) and protecting the FPC access to this screen by assigning an
Administrator’s password to qualified and knowledgeable personnel only.
Personnel logged in as users can edit the Date and Time (GMT) fields. All
other fields are reserved for administrators only. The Hardware (BME 0)
Address field and FPC IP Address field are hardcoded and cannot be changed.
Edit TCP/IP fields as follows:
1. Touch the blue Admin > purple TCP/IP buttons.
The TCP/IP
screen appears.
2. Touch the field you want to edit. Depending on the field you touch, either the
on-screen alphanumeric keyboard (figure 3-1) or an on-screen numeric
keypad (figure 3-2) appears.
3. Enter the desired parameter using the keyboard or keypad.
4. Touch the green Take button to accept the changes
or touch the
green Cancel button
to reject the changes.