Filter
Top Products
LockIt Lacing Bracket
LockIt lacing brackets are provided to secure the HDMI cables to the rear panel connectors
as shown. The configuration of the HDMI connectors on the MPS602 rear panel require
using a top mount (HDMI input 3) and a single or stacked side mount (HDMI inputs 4 and 5)
installation to secure the three inputs.
To secure a single HDMI cable in HDMI inputs 3 or 4:
1. Loosen the HDMI connection mounting screw from the panel enough to allow LockIt
lacing bracket placement.
ATTENTION:
• Do not remove the HDMI connection mounting screw.
• Do not overtighten the HDMI connection mounting screw. The shield it
fastens to is very thin and can easily be stripped.
2. Plug the HDMI cable into the panel connection.
3. Place the LockIt lacing bracket on the screw and against the HDMI connector, then
tighten the screw to secure the bracket.
4. Loosely place the included tie wrap around the HDMI connector (or connectors in a
stacked configuration) and LockIt lacing bracket. Hold the connector securely against
the lacing bracket and tighten the tie wrap, then remove excess length.
To secure two HDMI cables in HDMI inputs 4 and 5:
A single LockIt bracket can secure two HDMI connectors in a stacked configuration as
shown below. In step two above, plug both HDMI cables into the panel and secure both
with the tie wrap in step four.
5
4
4
2
1
2
3
4
4
4
Side Stacked
4
Top
3
Figure 11. Lockit Lacing Bracket Installation
MPS602 • Installation 10