Filter
Top Products
USING SETUP MODE
1. Enter setup mode.
Press the AUTO GAP button and the HI IMPACT button
>>
<< FUNCTION >>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG GAP-ADJ DEFAULT LIST SELF-TST
HEX-DUMP V-ALMNT INITIAL
simultaneously until the printer beeps. Wait for the printer to
stop printing and check that the following <<FUNCTION
menu is printed:
2.
position the cursor on the left edge of the aluminum print guide
on DEFAULT. Press the S button or the T button to select the
>
.
3. Do either of the following:
1 or MENU2.
This ollowing diagnostic functions:
•
•
• V-ALM
These fu
printer p
program rs
Printing the Self-Test
The SEL T
operates inde
the interface between the co
ns,
.
L24C PLUS emulation is selected for MENU1, the self-test is
printed using the settings currently assigned to MENU1.
USING THE
DIAGNOSTIC
FUNCTIONS
Select the DEFAULT function.
Repeatedly press the “TEAR OFF” or “LOAD” button to
DEFAULT function. The printer reprints the <<FUNCTION>
menu. The default values in MENU1 and MENU2 are now reset
• Select new options for MENU
• Exit setup mode, saving the factory defaults.
See the section MENU1 and MENU2 Items and Options. To
exit setup mode and save the new defaults, make sure that the
cursor on the left edge of the aluminum print guide are
positioned on SAVE & END, then press the S MICRO button
or the T MICRO button.
section describes how to use the f
SELF-TST
HEX-DUMP
NT
nctions are used for checking print quality and diagnosing
roblems. HEX-DUMP also provides useful information for
me .
F- ST function prints test pages to check how the printer
pendently of your computer. The self-test does not check
mputer and the printer.
The self-test prints the printer’s firmware version, its resident emulatio
and all of the characters available in the currently selected character set
If the DP
5-52 User's Manual