Filter
Top Products
PRINTING
CAUTION
When printing remaining lines, be careful not to print on the platen.
Printing on the platen may damage both the platen and the print head.
Continuing printing after supplying paper
1. Install paper on the forms tractors or on the cut sheet stand, or in
the cut sheet feeder bin, as described in Chapter 3.
2. To load the first sheet of paper, press the LOAD button. The
PAPER OUT indicator will turn off.
3. Press the ONLINE button to place the printer online. The printer
resumes printing.
NOTE
For continuous forms paper, the page where printing
stopped and the page where printing resumes may be
incorrectly printed. In this case, wait for the entire job to
finish printing. Then reprint the incorrect pages.
Resuming after an Area Over warning
The printer senses the left and right edges of paper and stores their
positions when the paper is loaded. If your software will print data past
either edge, the printer ignores that data but does not stop printing.
The AREA OVER detection control functions when AREACNT (area
control) is set to ENABLE in setup mode. See Chapter 5 for information
on setting AREACNT. The factory default is not to sense the edges. If
paper is dark-colored or preprinted, the printer may not be able to sense
the edges correctly. In this case, disable the sensor.
User's Manual 4-7