Filter
Top Products
PAPER HANDLING
Loading Continuous Forms (Rear Feed)
A tractor is supplied as standard and is attached to the front of the printer.
It can be attached to the rear of the printer. You can also buy a tractor
unit as an additional rear tractor unit.
A maximum of 8-ply media can be fed from the rear tractor unit.
• Put the paper table in the normal mode when the rear tractor unit
is to be used.
For reinstalling the tractor unit for rear feed, see page 2-10 to 2-13.
1. Press the PAPER PATH button to select REAR TRACTOR (the
indicator lights).
2. Set the continuous forms.
Go to step 3-8 in the section Loading Continuous Forms
(Front Feed) in this chapter.
3. Load the continuous forms.
Go to step 9 in the section Loading Continuous Forms (Front
Feed) in this chapter.
Unloading Continuous Forms
To unload continuous forms:
1. Make sure that the FRONT TRACTOR or REAR TRACTOR
indicator lights.
2. Press the LOAD button. The continuous forms paper is retracted
to the park position. If the paper cannot be retracted in one
operation, continue to press the LOAD button until the paper is
parked.
NOTE
The printer can retract continuous forms paper up to a
maximum of 55.8 cm (22 inches) per operation.
3. To remove the paper, raise the tractor paper holders and lift out
the paper.
NOTE
If continuous forms are unloaded without stopping, the
paper may slip off the tractors.
User's Manual 3-19