Filter
Top Products
Important Information
86 EN/LZT 108 6377 R4 - September 2003
FCC Part 68
11.3.4.1 FCC Part 68 Statement
The Federal Communications Commission (FCC) has established Rules
which permit this device to be directly connected to the telephone network.
Standardized jacks are used for these connections. This equipment should
not be used on party lines or coin phones.
If this device is malfunctioning, it may also be causing harm to the
telephone network; this device should be disconnected until the source of
the problem can be determined and until repair has been made. If this is
not done, the telephone company may temporarily disconnect service.
The telephone company may make changes in its technical operations and
procedures; if such changes affect the compatibility or use of this device,
the telephone company is required to give adequate notice of the changes.
You will be advised of your right to file a complaint with the FCC.
If the telephone company requests information on what equipment is
connected to their lines, inform them of:
The telephone number to which this unit is connected
The USOC jack required
The FCC Registration Number (indicated on the label).
The Ringer Equivalence Number (REN). Note that if several devices are
connected on the same line, the RENs must not add up to more than 5.0.
This REN figure is important to your telco and can be found on the
equipment’s FCC compliance label.
In case of operational problems, disconnect your unit by removing the
modular or multi-connector plug from the telco’s jack. If your regular phone
still works properly, your modem has a problem and must remain
disconnected and (officially) serviced or returned for repairs. If upon the
above disconnection your regular phone still has problems, notify your telco
that they may have a problem. If problem is still found in premises wiring
not telco-installed, you are subject to a service charge. If a fault is found in
telco-installed wiring, you may still be subject to a service call charge.
Unless otherwise noted in the User’s Manual (e.g. fuses, etc), user may not
under any circumstances (in or out of warranty) attempt any service
adjustment, or repairs on this unit. It must be returned to the factory or
authorized U.S. service agency for all such work. Locations and phone
number of factory or authorized U.S. service points are as following: