Filter
Top Products
System Access 9
Replacing the bezel
After installing a 5.25-inch device or replacing the 3.5-inch diskette drive,
replace the front bezel before you replace the side panel.
1. Position the bezel to the front of the chassis so that the bezel pegs are
aligned with the mount holes on the front of the chassis. See Figure 5.
Figure 5: Replacing the Front Bezel
2. Insert the bezel pegs into the correct holes at the top of the chassis.
3. Swing the bottom of the bezel forward and press the pegs into the
correct holes, securing the bezel to the chassis.
4. Secure the bezel with the two screws you removed when removing the
bezel.
To Replace the Front Bezel
4075.book Page 9 Friday, April 2, 1999 9:26 AM