Filter
Top Products
CHAPTER 4: Advanced Hardware Setup
48
10 Press F10 to exit BIOS, then press Y to accept the
changes. The screen displays the message “Turn off
power and reinstall the jumper in Normal mode
position.”
11 Turn off the computer.
12 Disconnect the power cord and follow all anti-static
precautions.
13 Return the jumper to the Normal position (bridging
pins 1-2).
14 Close the computer case.
15 Reconnect the power cord.
16 Turn the computer on. If the jumper is in the correct
position and the multiplier is low enough, your
computer should start normally.
Setting up multiple monitors
To set up multiple monitors, see the “Customizing” chapter in
your online User Guide.
8512162.book Page 48 Tuesday, February 13, 2007 3:44 PM