Filter
Top Products
7 - 15
RS-232 Serial Commands
Click on View - Serial Command Window to display the Command Center
window which allows you to enter serial commands to the Imager. Click on View
- Scan Data Window to open a window which displays serial data in a text
format.
Serial commands are used to program the Imager and to query the Imager about
programming parameters. The serial programming commands are listed
beginning on page 7-20. Information about performing queries is listed on page
page 7-17.
Serial Programming Commands
The serial programming commands can be used in place of the programming bar
codes listed in Chapter 3. Both the serial commands and the programming bar
codes will program the Imager. For complete descriptions and examples of each
programming command, refer to Chapter 3.
To enter a serial command, click in the Enter Menu Command text box and type
in the command(s) you wish to use. If you are typing in more than one command,
separate the commands with a semicolon (;). Click on Send Command to send
the command(s) to the Imager.