Filter
Top Products
2 - 13
Hardware Flow Control
When hardware flow control is
On
, the software checks for a CTS signal before
sending data. This option is useful when your application supports the CTS
signal.
Software Flow Control
This allows control of data transmission from the Imager using software
commands from the host device. When this feature is turned
Off
, no data flow
control is used. When Data Flow Control is turned
On
, the host device suspends
transmission by sending the XOFF character (DC3, hex 13) to the Imager. To
resume transmission, the host sends the XON character (DC1, hex 11). Data
transmission continues where it left off when XOFF was sent.
On
* Off
* Off
On